Surround panel
A surround seals the face of the fireplace around the unit sized to the fireplace face.
An open masonry fireplace sends most of its heat up the chimney, and a fireplace insert installed in Stroudsburg turns that firebox into an efficient, closed heater. Dial (272) 271-1491 to be connected with a local installer for gas, wood or pellet inserts.
Most of the heat from an open wood fire goes straight up the chimney, taking warm room air with it. By sealing the opening and metering the air, an insert burns fuel slowly and sends its heat into the room instead of up the flue.
Installation starts with the chimney, not the insert. Adding an insert changes the venting system, and under the NFPA 211 standard that calls for a Level 2 inspection, usually with a camera run up the flue. Repairs to the crown, flue or smoke chamber come before the install, while access is still easy.
A full-length stainless liner, sized to the insert outlet, is the standard way to vent a modern insert. An old masonry flue is often far larger than the insert outlet, which lets exhaust cool, draft poorly and leave heavy creosote. Insulating the liner helps even more in a chimney built on an outside wall.
Depending on what the sweep finds, fireplace insert installation in Stroudsburg, PA can go hand in hand with chimney liner installation and gas fireplace repair.
Looking for Stroudsburg fireplace insert installation? Call (272) 271-1491 and describe the problem to a chimney sweep who works in Stroudsburg.
Call nowA good insert installation is mostly about measuring carefully and venting properly.
The installer examines the whole system, often with a camera up the flue. Needed repairs are handled first.
The front width and height, rear width, depth and hearth are measured so the insert fits the opening. The distance to the mantel and side trim is compared with the manufacturer clearance chart.
A full-length stainless liner goes in from the top, often wrapped in insulation, then capped at the top.
With the liner in place, the insert is set and connected. Gas units are connected to the gas supply and leak tested at this point.
A test fire confirms the draft and that smoke goes up, not out. Ask about break-in fires, which cure the paint and should be kept small.
A surround seals the face of the fireplace around the unit sized to the fireplace face.
The hearth in front is checked against the floor protection the insert requires before the first fire.
A properly sized flexible or rigid stainless liner with insulation where it is needed.
A full look at the flue, smoke chamber, crown and hearth before the install to catch problems before they are covered up.
The liner is capped and the crown sealed around it so water and animals stay out.
A gas fireplace insert is a sealed, direct vent unit that fits inside an existing wood-burning fireplace and burns natural gas or propane. Venting usually uses a two-liner system inside the old flue, so the unit draws outside air and never uses room air for combustion. A gas line has to reach the firebox, and local code decides who may do that work and whether a permit is needed.
For Stroudsburg homes, a gas insert means instant flame, remote or thermostat control and no wood to store. Some ignition types can still light during a power outage, though the blower will not run. Plan on an annual service of the pilot, burner and vent.
Wood inserts are essentially wood stoves shaped to fit a fireplace opening, with secondary combustion that burns off smoke for a cleaner, hotter fire. New wood heaters sold in the US must meet EPA emission limits, so a modern insert makes much less smoke and creosote than an open fire when it is fed dry wood.
Burning dry wood is what keeps a Stroudsburg wood insert running clean, and a moisture meter can confirm it is ready. Plan to have the liner swept every year, since an insert makes the chimney harder to reach from below.
Many fireplaces in Stroudsburg were built for looks as much as heat, with large clay-lined flues that suit an open fire but not a modern insert, which is why a full-length liner is part of nearly every install. In Stroudsburg and nearby towns like Arlington Heights, East Stroudsburg, Penn Estates and Bangor, rain and seasonal temperature swings wear on crowns and flue tiles, so the inspection before an insert often turns up masonry work worth doing first.
Searching for fireplace insert installation near me from Stroudsburg or Arlington Heights, East Stroudsburg, Penn Estates and Bangor? Call (272) 271-1491 to talk to a chimney sweep who works in your part of town.
Winters here are long and cold, and the heating season usually runs from October well into April. Masonry takes the worst of it from the freeze and thaw cycle: water soaks into brick, mortar joints and the crown on a mild day, freezes overnight and expands, which is how cracks, loose bricks and leaks start. Nor'easters drive rain sideways into flashing and mortar that looked fine in summer. That is why chimney cleaning in Stroudsburg is usually booked in the fall, before the first cold night.
Small chimney problems caught early usually stay small repairs.
Local sweeps see the same chimney types and weather wear across Stroudsburg and nearby towns.
Ask the sweep about the cause, the options and the estimate before work starts.
More questions? Call (272) 271-1491
Putting a new liner in the flue sized to the fireplace, stove, furnace or water heater it serves.
Learn moreDiagnosing pilot, igniter, valve and venting faults on gas fireplaces, including direct vent, B-vent and vent-free units.
Learn moreSetting up a new wood stove from hearth pad to chimney cap, with stovepipe, liner or chimney sized to the stove.
Learn moreRestoring masonry and factory-built fireplaces so they burn cleanly and safely again.
Learn moreLooking for something else?
See all chimney servicesCall (272) 271-1491 for a local chimney sweep in Stroudsburg and nearby towns.
Free to call. No forms to fill out.